All Products

Displaying 2431 to 2440 (of 3105 Products)
(image for) L9110S Motor Driver Module
M088

L9110S Motor Driver Module

2-channel H-bridge motor driver board able to drive two independent motors at up to 800mA each. Can also drive a single four line two phase stepper...

£0.94
Add:
(image for) Lampholder
OP034

Lampholder

MES E10

£0.48
Add:
(image for) Laser Module 5V 5mW 650nm
OP176

Laser Module 5V 5mW 650nm

Laser diode module. Operating voltage 5Vdc. Wavelength 650nm. Output power 5mW. Housing diameter 6mm. WARNING: Do not look directly at the beam.

£0.98
Add:
(image for) Latching Squid Push Switch
SW208

Latching Squid Push Switch

A pushbutton with trailing leads and built-in resistor that can be connected directly to the GPIO pins of a Raspberry Pi, Pico, etc. for additional...

£4.20
Add:
(image for) LD1085V
QD182

LD1085V

Adjustable 3A Low Drop Out TO220

£1.68
Add:
(image for) LD1117V33 3.3V 800mA
QD353

LD1117V33 3.3V 800mA

3V3 800mA Low drop-out voltage regulator. 1% tolerance. TO220 package.

£0.62
Add:
(image for) Lead Tester Kit
K128

Lead Tester Kit

Create a continuity tester for any lead with up to 8 wires eg Ethernet patch leads, DIN audio leads, USB etc. NOTE: Connectors are not supplied -...

£5.56
Add:
(image for) LED Ring Kit
K072

LED Ring Kit

Project constructed on the supplied PCB. Red and green LEDs flash in a rotating pattern with the speed adjustable using a preset pot. Kit contains...

£5.95
Add:
(image for) LED Spacer 13mm
OP133

LED Spacer 13mm

Reliably space and support your LED above the PCB - for 5mm leds. 5mm diameter, 13mm long.

£0.11
Add:
(image for) LED Spacer 9.85mm
OP113

LED Spacer 9.85mm

Reliably space and support your LED above the PCB - 5mm leds. 5mm diameter, 9.85mm long.

£0.17
Add:
Displaying 2431 to 2440 (of 3105 Products)