Red Snapper Clone - 3 Knob

  • Model: K089

 Ask a Question 

£12.91

Add to Cart:
"The Red Snapper debuted in 1996 to fill the need for a very open and uncompressed overdrive. It can produce anything from a clean boost to enough drive to make any amp sing. Its overdrive character was painstakingly designed to keep your amp and guitar's illustrious tone perfectly in tact."

A kit of components as recommended by Ivlark for assembly of the Red Snapper 3-Knob stripboard project.
NOTE - these kits are not intended for beginners, so the ability to identify components and values from their markings and to transfer a pictorial layout to physical stripboard is assumed. No written instructions are provided with the kit.
Latest assembly guides and layout are available here.


Manufacturers and product names are mentioned solely for circuit identification and comparison, and where applicable the trademarks are the property of their respective owners who are in no way associated or affiliated with Bitsbox. No cooperation or endorsement is implied.

Kit Contents:
  • Resistors:
    • 1x 1k Metal Film Resistor 0.25W 1%
    • 5x 10k Metal Film Resistor 0.25W 1%
    • 1x 33k Metal Film Resistor 0.25W 1%
    • 2x 1M Metal Film Resistor 0.25W 1%
  • Capacitors:
    • 1x 47nF Polybox
    • 2x 100nF Polybox
    • 1x 1nF Polyester Film
    • 1x 47uF 25V Electrolytic
    • 1x 47uF 25V Electrolytic Axial
    • 1x 100pF Ceramic Disc Capacitor
  • 1x 4558 Dual Opamp
  • 3x 1N4148 Diode
  • 1x 64x95mm Stripboard
  • 1x 3PDT Footswitch
  • 1x 2.1mm DC Chassis Socket
  • 1x 1M log 16mm Potentiometer
  • 1x 22k lin 16mm Potentiometer
  • 1x 250k log 16mm Potentiometer
Note: Obsolete components will have been replaced by currently available recommended substitutes - more information available via the blog here.

To complete your project you might be interested in:

Wire diecast box jack socket control knobs switch
Your IP Address is: 18.97.9.175
Copyright © 2024 Bitsbox. Powered by Zen Cart