MXR Microamp Clone

  • Model: K095

 Ask a Question 


Add to Cart:
"Adding a preset amount of gain with just a single control, the Micro Amp is a great way to boost your signal for lead work or adjust between two different guitars with unmatched output (i.e. humbuckers to single-coils). It can also provide a permanent boost in a long effects chain where signal drop off is a problem."

A kit of components as recommended by Ivlark for assembly of the MXR Microamp stripboard project.
NOTE - these kits are not intended for beginners, so the ability to identify components and values from their markings and to transfer a pictorial layout to physical stripboard is assumed. No written instructions are provided with the kit.
Details and layout available here.

Manufacturers and product names are mentioned solely for circuit identification and comparison, and where applicable the trademarks are the property of their respective owners who are in no way associated or affiliated with Bitsbox. No cooperation or endorsement is implied.

Kit Contents:
  • Resistors:
    • 1x 470R Metal Film Resistor 0.25W 1%
    • 1x 1k Metal Film Resistor 0.25W 1%
    • 1x 2.7k Metal Film Resistor 0.25W 1%
    • 1x 10k Metal Film Resistor 0.25W 1%
    • 1x 56k Metal Film Resistor 0.25W 1%
    • 2x 100k Metal Film Resistor 0.25W 1%
    • 1x 2.2M Carbon Film Resistor 0.25W 5%
    • 1x 10M Carbon Film Resistor 0.25W 5%
  • Capacitors:
    • 1x 4.7uF 40V Electrolytic
    • 1x 15uF 50V Electrolytic
    • 1x 1uF Multilayer Ceramic
    • 1x 47pF Ceramic Disc
    • 1x 100nF Polyester Film
  • 1x TL061A JFET Op Amp
  • 1x 500k Reverse Log 16mm Pot
  • 1x 64x95mm Stripboard
  • 1x 3PDT Footswitch
  • 1x 2.1mm DC Chassis Socket
Note: Some components from the original design may have been replaced by recommended substitutes - more information available via the blog here.

To complete your project you might be interested in:

Wire diecast box jack socket control knobs switch
Your IP Address is:
Copyright © 2024 Bitsbox. Powered by Zen Cart